Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Recent content by faraz7777

  1. F

    500 points for naming a new PIC Microcontroller book

    Congratulations to you two ! Good Luck .
  2. F

    Refrigerator problem with the condenser

    Re: Refrigerator Problem Start the refrigerator when the other instruments are off , and the voltage stabilizer is out of service ; in this way you can find out if the voltage is low for it or not. If it works normally , you could use the stabilizer in service now, and find if there is any...
  3. F

    WHICH IS FAST? BJT or MOS

    As a general answer we should select BJT as the faster one... BUT when we say about the switching and digital ckt, CMOS is the winner, since its newer technology helps it to use narrower channels to get the winning speeds. In analog ckt, when we don't use a BJT is saturation mode,and it is in...
  4. F

    BJT is definitely faster than MOS....Please acknowledge....

    Re: BJT is definitely faster than MOS....Please acknowledge. As a rule, we should say BJT is faster than CMOS.... BUT it is not a complete rule, because nowadays there are some CMOS technologies that can rival with BJTs in speed !
  5. F

    help me more document about Fuzzy Control

    Fuzzy control: www.ece.osu.edu/~yurkovic/FCbook.pdf Fuzzy logic to control: dce.felk.cvut.cz/labcsma/soubory/Fuzzy_control.pdf Fuzzy systems for control applications: www.site.uottawa.ca/~petriu/Fuzzy-tutor.PDF Cheers, faraz7777
  6. F

    Study on Diode. Please give some help~

    You may use : recombination in Diodes: www.springerlink.com/index/X5N00V25G8272974.pdf recombination lifetime: ieeexplore.ieee.org/iel5/6755/18059/00836419.pdf
  7. F

    12V to 240V interverter circuit

    inverter 12v 240v circuit You may find sth. useful here: https://upcommons.upc.edu/e-prints/bitstream/2117/1268/1/RobustStepup.pdf And more professional you may read this article...
  8. F

    Looking for information about step up chopper

    step up choppers You may find your answer here: www.eetasia.com/ARTICLES/2007MAR/PDF/EEOL_2007MAR16_POW_CTRLD_TA.pdf - Or here: www.catsemi.com/datasheets/4240.pdf This may help you too: www.egr.msu.edu/classes/ece480/goodman/spring/group05/docs/AppNote-reemmerb.pdf - Good Luck ! faraz7777
  9. F

    BJT is faster than MOS-Every reply will b clicked helped

    As a matter of fact, the first advantage of CMOS ckt is its lower energy consumption, and the ability of usage with several levels of voltages... eg. we need 5 volt for BJT 74xxx ICs, but not necessarily for 74cxxx ones. However, in some cases we may see a very fast modern CMOS IC which has...
  10. F

    how does a capacitor charge in negative

    Hi. I should confirm fsahmed another time. He has good information on capacitors, and he almost said anything about Cap.s and the effect of higher voltages on their sizes. You may use ceramic or mylar capacitors for your higher voltage applications.
  11. F

    What is the resolution of pic microcontroller?

    Re: resolution Resolution is a describing adjective for some electronic instruments which are involved with data acquisition, sending, or receiving... Then resolution shows the quality of the data. For example, an HDTV has a very higher resolution than a conventional TV; because the pixels of...
  12. F

    Replacement for 2N7000 transistor

    Re: Transistor Hi. How do you do?! BS170 is a good replacing candidate,you only need to notice the pin-out ! I put the information in the attached file for you. VQ1000j and VQ1000p are suitable replacements also, but they are in Dual-in-Line package. You may use NDF7000A easily too. Its pin...
  13. F

    How to measure AC voltages from stage to stage

    ac voltmeter measurement opamp Hi ! I am happy hearing so good questions. I confirm the previous aiding tip written by Mr/Ms. laktronics. AND suggest you to use the voltage follower ckt instead. It is a simple circuit built with an op-amp,that follows right voltage to the output without putting...
  14. F

    Help me connect 555 circuit to two different power sources

    Re: 555 CIRCUIT I suggest putting a 56ohm resistor at collector, and changing the base resistor to 7.4k-ohm. Then the current of LEDs is limited to 100ma, and the transistor gets its saturation level very well. In this way, the consumption of your circuit lowers ,and you have no problem with...
  15. F

    telephon remote hang up detector circuit

    I suggest you to use a simple op-amp, to get and recognize the voltage level of tel line. If it is less than 15-20volts, you can detect the hanging off. Good Luck.

Part and Inventory Search

Back
Top