Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Recent content by eeeanisur

  1. E

    multi standard baseband processor design

    Hi All, I want to design a multi standard baseband processor for my FYP as suggested my Supervisor. I have to do it by MATLAB/SIMULINK. Where should I start form? Which design i have to make? Can anyone give me some necessary citation relating the project?
  2. E

    12 V power supply original rating

    No , no problem in these equipments as i say there are 12V in laptop batteries so it needs much voltage then 12V. But is it need 17.5V ?
  3. E

    12 V power supply original rating

    The 12 V power supply such as Laptop charger or adapter shows around 17.5V in my 2 multimeter(Analog + Digital) as well as in our lab oscilloscope where rated 12V. Now i want to connect it with a 12V geared motor. Is any problem to connect it across these adapter.I also tried it using another...
  4. E

    Line follower robot using LDR+Atmega(8/32/48)+c code

    Ya , My problem is in programming section. I have done the sensor using 3LEDs + 3LDRs and comparator(LM324). Where the outputs are around 5 volts (HIGH) and .5 offset voltage (LOW) for the microcontroller . Also i have L293D motor controller IC + i have make a small car. But still i have a...
  5. E

    Line follower robot using LDR+Atmega(8/32/48)+c code

    I need a line follower robot using IR+LDR+Atmega(8/32/48)+c code urgently. As t have all the components above.
  6. E

    Line follower robot sensor problem.

    Can i make a Line follower robot using LDR or IR Receiver (i don't want to use phototransistor as mention below)and Atmega series microcontroller (Atmega8 or 32 or 48 ,these uc i have).Please give me some idea + reliable site. ####The voltage across the phototransistors are same and current is...
  7. E

    Iinterfacing usb and any circuit

    Sorry.Above one means the question.
  8. E

    Iinterfacing usb and any circuit

    Ya i have done it with a uc controlling 8 LEDs. But now i want the above one.
  9. E

    Iinterfacing usb and any circuit without microcontroller.

    Can anyone help me to interface usb and any circuit which is controlled by usb and software without help of any microcontroller.
  10. E

    Iinterfacing usb and any circuit

    Can anyone help me to interface usb and any circuit which is controlled by usb and software without help of any microcontroller.
  11. E

    Atmega8L instead of Atmega8 in USB-ASP

    Is there any change/problem in USB-ASP Circuit if i use Atmega8L instead of Atmega8.One of my friend has done it with the change of 56R instead of 68R at D+ D-.
See more

Part and Inventory Search

Back
Top