Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi all,
I urgently need some advices on this matter.
I used Virtuoso layout editor to draw some circuit. I need to perform LVS with Dracula.
Could anyone show me how to set up connections, like VDD, VSS, IN, OUT, in Virtuoso etc.. so that Dracula can recognize these.
I use "Create > Pins "...
Hi timof,
Thank you very much for your response,
1. Would you please tell me what free software can I use? I curerntly use Fasthenry for R/L extraction and fastcap for C but we need a more precise one to extrace R, C and L at the same time.
2. Accuracy, speed and net size approximately similar...
3d capacitance software
Dear everyone,
Please help me to recommend the abovementioned software. I need to get one for a complex metal wiring design.
Thank you very much
Dear Psmon,
Since the design is of high complexity and not so repeatitive and draw a few layers will be too time-consuming. And it will be the last resort I'm gonna look at.
cadence layer
Dear all,
Would you please help me since I need to export a few layers from a design to send to a manufacturer and due to security issues I can only send a few layers, can anyone help me about this?
Really appreciated your help.
Best regards,
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
