Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Yes the servos are 3 pin.
+5 power
Ground and reference
Signal
The signals from the Tx do not have to be constant to all servos but if there is no signal then power should not be applied or the servos will chatter. Also with no signal and power the servos can be free wheeled easy but this...
Hey everyone. I am Dominic, I am just getting into the hobby of electronics but I have a good background playing with electrons.
I was an AT in the Navy, and was really good at fixing the radar assemblies from the F14 and E2C both on the RF and digital side. My experience is mainly in repair...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
