Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I have both programmers too. But I can't use PicKit3 programmer with my compiler. I use mikroPascal Pro or microC Pro compilers for my codes. Because these compilers don't support PicKit3. But PicKit2 has personal software (on PC) and I use it for writing microcontrollers.
If you want to use 4xAA cell you can by cheap linear low drop-out DC-DC converter MIC5205-3.3BM5 for 3V3 or MIC5205-5.0BM5 for 5V0. If you want to use 2xAA cell you can use MAX1795 (for changing output voltage you need in only one jumper).
Can I see your definition of this copper pour and project Clearance rules? I think you have made mistake in definition of copper pour.
Added after 3 minutes:
I can't define clearance rule for my polygon. I want to make clearance from polygon on top layer to board outlines. I use AD summer 2009.
I did PICKIT2 two yeas ago. PCB of my device intends for manufacturing by hands. I use it two years and I have never had any problems with my device. You can see picture of PCB on my homepage (**broken link removed**). If you want to read added text I will translate it.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
