Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Could you suggest me a complete book about electronic measurement? It should be about:
Multimeter
spectrum analyzer
Fourier analyzer
Wattmeter
logic analyzer
Automatic measurement
Impedence measurement
Thanks
I'm using Microwave Office for simple microstrip filter design: I use the circuit schematics with models of trasmission line based on quasi-static approximation.
I'd like to know what kind of numeric method the program use to simulate the circuit and get the frequency response of the filter.
Perhaps the reference point is f0. If I have understood, that requirement is about the slope in pass band, right?
What I should use as ripple to evaluate the order of a Chebyshev filter, 4.5 or 0.2 or 2?
Excuse me but I'm still a bit confused.
---
Another question: about the impedance, the...
Thanks
So if IL at f0 is 3dB, then the passband must be above -5dB, right?
Could you please explain deeply the last requirements? What means "in any BW 25 MHz"
Is the ripple the maximum range of oscillations or its half?
I have to design a filter with the following requirements:
Type Bandpass
Nominal center frequency (F0) [GHz] 12.5 GHz
BW 2 dB [GHz] 12-13
Insertion loss @ F0 [dB] 4.5 max
Rejection band 30 dBc [GHz] [10-11.6;13.4-14.5]
Rejection band 40 dBc [GHz] [16-18]
Rejection band 60 dBc [GHz]...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
