Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hello All,
This is a question apart from Technical.
What does the future holds for BOARD DESIGN Engineers in INDIA for the next 10 Years.
With Regards,
Deepak Sibi
Hello All,
I would like to post in this forum that I have all the Electronics for You magazines for the past 5 Years.
Its readily available at my place.
Please let me know if any one is interested.
With Regards,
Deepak Sibi
Hello All,
Please mail me some good reference documents on Memory Interface to a 32 bit processors especially with Intel,ARM Processors.
Please mail me at deepak(dot)sibi(at)gmail.com.,for the documents.
TIA.,
Deepak
Battery Management
Hi All,
I am in need of a good technical document which explains the concepts of battery management and battery charger circuit.
Please mail me at deepak(dot)sibi@gmail.com.
TIA.,
Deepak
lc pi filter
Hi All,
Can any one give some technical details on Asymmetrical Low Pass LC Pi Filter.
Here the meaning of Asymmetrical means the Capacitors (C1 AND C2) in the Circuit will be having different values.
Also I need the Transfer function and the formulae for the same.
Kindly...
Hi All,
Can any one give me a brief idea about the process of POWER SEQUENCING done when there are multiple voltage supplies on the board?
TIA.,
Deepak
Hi All,
1.What are all the design considerations should I consider when I want to route 2.4 Ghz on a 4 Layer Board keeping the stack up as follows :
4 Layer Stack up :
1.Top
2.Gnd
3.VCC
4.Bottom.
Please reply with your opinions.
2.What is Balance Stackup in PCB Design?
TIA.,
Deepak
Hi All,
Thanks for the reply.
But for the last reply to my friend I am using a 200Mhz Tektronix Scope and I want to measure a Signal of 2.4Ghz.
Can it measure is my Question.Also with 200 Mhz Socpe upto what waveform can I measure.
TIA.,
Regards
Deepak
Hi,
1.What is the relation between Sampling Frequency and Bandwidth when you are using a Scope?
2.What is the maximum frequency you can measure on a 200 Mhz Oscilloscope?
TIA.,
Regards
Deepak
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.