Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi,
I understand u have data with 100 samples per second [fs or the sampling frequency] ( assuming dt = 0.01s is the sampling interval)
this will give your nyquist frequency as fs/2 = 50 Hz, this is important as the cut off frequency of your filter is normalized with respect to the nyquist...
re: Relation between BER & SNR for BPSK
For BPSK, the probability of error, BER = Q(sqrt(2Eb/No))
where Eb/No is the absolute SNR per bit (not dB) and
Q(X) is the common Q-function (area under Gaussian for x>X)
Hope it helps
So i have written the code to generate GMSK signal, but i m not sure if it is correct
it generates a low pass envelope over the PSK signal
Also i wanted to ask if the way i m integrating to obtain phase is correct.
I am doing summation
Please Help Me
f_simulation = 20*10; %MHz
fc =...
Its working principle is flow of charge (essentially current) in a magnetic field thereby generating motion. In the heart of it , it is the current that needs to be modified.
However, in working to control a DC motor we apply varying voltage(controlled by us) which in turn changes the current...
hi i m getting the following error, irrespective of the make target
this is just one example with target as clean
droy@m4210-01 ~/linux-xlnx-master $ make ARCH=microblaze clean
scripts/Makefile.clean:17: /home/droy/linux-xlnx-master/drivers/net/ethernet/smsc/Makefile: File name too long...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
