Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
hello, the S2P file I am trying to edit is for ADL8142, the manufacturer does provide an S2p file but it excludes the noise figure data, so when simulated on ADS it shows the noise figure is equal to 0 basically making it an ideal LNA with the gain fluctuating within the operating frequency...
Hello,
In this schematic I’ve created, the S4P file is a hybrid and both S2P files are LNAs (same LNA). The output ports of the hybrid are each connected to an LNA, but when i run the simulation and plot S(2,1) and NF the gain (S(2,1)) is very small and even negative. The LNA’s gain should be...
As you can see from the photo, the file has the s parameters in phase and degrees, if i want to add noise to it how would the structure be? Would i just insert the values of noise after s22_Phase (deg). Is that format supported?
I am trying to simulate some components on ADS but every time for every single component, when I download the s2p file from the manufacturer ( I unzip the file ) and try to run the s-parameter simulations it say there’s an error.
What is causing this error?
Thanks
Please view the attached photo.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
