Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
hi
i have problem simulating mems shunt switch in hfss. i dont know how to obtain the s-parameters. please help me in excitation and defining proper ports to get s11 and s12
thanks
hi
i have problem simulating mems shunt switch in hfss. i dont know how to obtain the s-parameters. please help me in excitation and defining proper ports to get s11 and s12
thanks
im working on a cpw transmission line, not microstrip transmission line, also i dont know how to excite, with witch port, wave port or lumped port or...
hi evereybody
im trying to simulate a shunt capacitive switch on a cpw by ansoft hfss, but i have problems to excite the structure to obtain s-parameters. i dont know how and with witch wave port i should do the excitation. has anybody any idea??
First you will need to select a high quality OP amp with good linearity and thermal stability. Good thermal specs on the resistors as well. You could use a simple inverting design with a variable feedback resistor to calibrate the exact gain.
Example using first circuit in the op amp doc...
hi guys, is there any body who can help me designing a very accurate gain satge, which gain should be 8±0.001, it means error value must be less than 0.001. input voltage is 125 mv and therefore te output must be 1 volt. please help me, it's an emergency case!!
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
