Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi all
I got one spare digitizer and wanted to corvert to usable touch board but don't have pinouts, this is scanned picture
picture is small but this is all I can zoom
I know that this 2 connected from left can be GND but rest is problem, it is capacitive so it have to be i2C or SPI
Also...
Hi to all
After reading all documents and tutorials still need help around 19KHz sound generation
I have Atmega8 (can be Atmega168) and flow is next
It should generate 500ms quiet and 1000ms of sound
rising edge must be under 100ms
Can someone help me with this (I'm not so good with timers)...
attiny2313 7 segment
I have post picture in previous post...
In my case fuses were problem, post your project and I will help U.
Also and few modification in code you have to change
This is pdf from atmel
AVR093: Replacing AT90S1200 by ATtiny2313...
attiny2313 project
Hi
I have one little problem, I making this schematic
**broken link removed**
But I have to use ATTINY2313 instead 90S2313
Code is there but I can't figure it out what I have to change to work with ATTINY2313
Can someone help me here!!!!
PS. Only display 34C and after...
building com to usb converter
Hi
On internet you can find a lot of that.....
I recomend U this one
**broken link removed**
Direct download all files U need
**broken link removed**
It use Atmel microchips...
There is solution with FT232 and PL2303
So U chose.....
Regards
PS
use Search...
hi
I have make calculator for my project with AVR to help me with 5x7dotmatrix
code, and it's usefull, here it is...
And source code
**broken link removed**
:D
atmega usb driver
I have found this on www.obdev.at
**broken link removed**
when I connect device say Device not recognized-Unknown Device
P.S.
I'm not sure if I'm doing everything well, with firmware....
If someone has made this can post firmware here???
thx
Hi
I have Atmega8 and I need USB connection with PC, to control LedMatrix
Now, can someone help me to realize that, I have seen many with PIC
But not USB to serial and than, I need direct methode to comunicate with Atmega(
Thanks
virtual usb to serial converter
Here is very simple 2 versions of USB->RS232
One is with AT90S2313
Second is with ATmega8
- AT90S2313: 32 byte FIFO
- ATmega8: 800 byte FIFO
Communication speed and link parameters:
- AT90S2313: from 4800 baud to 57600 baud, 8 databits, 1 stopbit
-...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
