Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Recent content by crazy4analog

  1. C

    design of digital controller

    I want to design a switching regulator. However, I want the control loop to be digital
  2. C

    Specs to practise design of two stage cmos opamp

    I am new to analog design and want to practise my skills. can someone give me specs for 2stage cmos opamp design Thanks
  3. C

    Digitally controlled Regulator

    I am looking for information on digitally controlled switching regulator. Can someone help me with this. Thanks in advance
  4. C

    design of digital controller

    Does anyone know any book or paper that explains digital control of switching regulators (buck)
  5. C

    Output capacitor of buck converter

    I am reading a datasheet and it says output capacitor of buck converter affects its transient response. Can someone help me in understanding this statement? And how is the transient response measure for buck regulator.
  6. C

    Masters Project Proposal - suggestions needed

    Re: Masters Project Proposal Thanks Mr.Cool!!! I am googling the topic suggested by you. it seems interesting. Also I am looking into IEEE and APEC, however, I am not familiar with PESC, could you please elaborate. Thanks again for your help.
  7. C

    Masters Project Proposal - suggestions needed

    Masters Project Proposal Hi, I am about to start my Masters Project. My focus is for Power electronics, with some thorough exposure to analog design too. I was looking at different projects online and was wondering design a buck/boost converter similar to what the companies sell, would...
  8. C

    Open drain NMOS - how does it work?

    Re: Open drain NMOS Thanks for the reply!! In both these cases, does NMOS operate in saturation(active) or linear(triode) region? And how is it biased?
  9. C

    Open drain NMOS - how does it work?

    Open drain NMOS usually in circuit design an interrupt signal is through an open drain nmos. In applications a pullup resistor is connected on this open drain to indicate an interrupt. I would like to know how does this open drain NMOS works. I tried looking online, however, could not...
  10. C

    Output stage for op-amp without loading effect

    you could use a source follower
  11. C

    DC-to-DC Converter (or) Buck Converter

    this works: **broken link removed**
  12. C

    How to design trimming for a given circuit?

    Trimming ciruit How to design trimming for a given circuit? I tired to find the material to refer for trim circuit design, but could not find..i think i am not looking for right words :| Thanks
  13. C

    design of bandgap reference

    I designed a bandgap reference and plotted vref vs temp, i do not get the curve as is shown in all the text books. However, i get vref = 1.2V at room temp. Also i plotted the dvref/dt and do not get 0, at any temperature. I could not figure out what is wrong with the circuit. I am new to...
  14. C

    Help me with my circuit - Bandgap reference

    Re: Band gap reference Can someone please help me on this?
  15. C

    Help me with my circuit - Bandgap reference

    Band gap reference I designed a Bandgap reference to have a Zero Temp co at Room temp (25 deg C). I get 1.2V at 25C, however, the plot of Vref and temp does not look correct. Also, i plotted d(vref)/dT, and at any temperature it does not cross 0. I am attaching a copy of my schematic, plot o...
See more

Part and Inventory Search

Back
Top