Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Re: monte carlo in analog artist
I have the same problem. Even I could see the 100 run data file in the directory, however, it couldn't show up in the wavescan tools.
It is not the quesiton of enable the above option. The problem is wavescan could not find or get the other data files in the...
It is not a RF mosfet. I use a standard general purpose MOSFET and it is not a large transistor, (0.2/0.065)x4.
I also doubt the initial conditions of some MOSFET might cause such warning, and I run the trans before DC, the warning is still there.
Any other hints or ideal that I could try to...
I think the implementation of these algorithm is different, in different language, IDE or OS env. Even the same algorithm, there are some trivial difference , such as input processing, output length, etc. In general, you only need one which is most close to you application development...
Normally, after you write to the RS232 data register, there will be a flag in the status register or interrrupt, which depends on your setting in the control register.
dcOpInfo: writing operating point information to rawfile.
********************************
DC Analysis `dc': Vcm = (0 -> 1)
********************************
Warning from spectre during DC analysis `dc'.
WARNING (CMI-2426): I5.M3.m1: `Cdsc' = -416.981 mF/m^2 is negative.
WARNING...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
