Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi,
I'm trying to test a LNA but the only thing I get in the VNA is similar to noise.
When we need to connect the VDD and GND of a LNA to a power supply that is outside the test chip, we introduce a long path for the current. Or not?
It seems to me that the chip needs to have the power supply...
Thank you for your idea about the divisor, flatulent.
But I still have a problem. I need to do on-chip measurements and I would like to skip the job of adding a pcb. Also, when adding a pcb I need transmission lines that will load the output of my circuit.
About your idea of inductive loop, I...
Hi all,
I would like to know if it is possible to measure a RF signal (lets say at 5 GHz) at the output of a VCO, which is driving a PLL, without the need to design a buffer/driver/matching network at 50 ohm.
To have the circuit working I need a probe with around 1 kohm. I asked to some...
how to set spectrum analyzer in time domain
Hi people,
Is it possible to measure/view a signal in time domain using a spectrum analyzer?
If yes, how?
I asked a seller from agilent and the guy told me that what I need to do is to set the spanning frequency to zero?! Is that so?
Thanks in...
Re: Differences between HFSS Simulation Result and Agil ent'
I've used both software and I don't think @DS is more accurate and faster than HF@S. It depends on the structures you want to simulate and how long you want to wait for results. If you try to use @DS to simulate a circular inductor...
I need it for 6 GHz.
But my critical spec is the size. The 3.5 mm usually have 6x6 mm2. I have a device that is 4x4 mm.
I'll check your links to see what I can get.
thks
Small RF connectors
Hi guys,
what is the smallest RF connector i can have? is it possible to interface it with 3.5mm connector?
where can i buy, in europe, good and low budget RF connectors/cables?
thks
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.