Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Recent content by choto

  1. C

    GPRS Connection From One GPRS Modem to another ???

    connecting to gprs modem Hey it seems you hve worked alot on GSM/GPRS stuff. i need help. i am using sim340 gsm/gprs modem and i want to connect gsm/gprs modem to other gsm/gprs modem. I have established connection successfully in non transparent mode for CSD calls but now I want to establish...
  2. C

    GPRS with 8051 - interfacing, how to assign IP address

    8051 gprs schematic hi can anybody help me in interfcaing uP's serial port with sim340E. I have connected RXD,TXD nad GND signals to uP and powered up using power key but VDD_EXt doesnot give any output signal (it should be 2.93V) and no response for AT commands. Is anyother signal required...
  3. C

    help regarding sim340e - help me in selecting antenna

    Re: help regarding sim340e thnx and what antenna length should be preffered for GSM 900/1800 MHz???shorter or longer one? I have seen one, it is half wave dipole thumb antenna(900/1800Mhz, 20ohms) with two lengths available 5cm and 10cms. i think shorter gives better reception n trnasmission...
  4. C

    help regarding sim340e - help me in selecting antenna

    sim340e hi guys, I am new to GSM and i wnat to use sim340E GSM modem. I have to interface it with 8051 controller and have to reaceive/transmit data through GSM network. I have selected sim340E but now i am cofused about antenna. Can anybody help me in selecting antenna. What will eb a...
  5. C

    GSM/GPRS module and camera

    uart gprs module hi everyone, i want to interface sim 340e with uart of controller 8051 and want to transfer some data through GSM service provider. is it possible to send large amount of data this way??

Part and Inventory Search

Back
Top