Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi
Aim generating the frequency 0-1.5KHZ from 89C51 micro controller.
Now I want convert this frequency to audio. Aim using 8 ohms speaker.
Can you suggest any audio IC that converts frequency to audio?
Thanks
Regards
chandu
Re: volume control
Hi
My doubt is how to generate the variable frequency with constant amplitude using 89C51.
The variable frequency is depends on analog input voltage.
So aim planning to take digital value corresponding to the analog input voltage and place the digital value in the TIMER...
Re: volume control
Thanks for the reply
Here I am comparing the external signal with set point value. Set point value is variable. It well changes to user to user. According to the set point value I want generate the PULSES and give to any musical IC, which generates the sound.
My problem...
volume control by 89c51 chinese
Hi
How to convert the voltage into pulses (frequency) using 89c51 micro controller?
Aim using AD571 ADC and converting analog voltage in to digital and feeding to microcontroller.
For microcontroller I connected a Buzzer. Depending on input voltage its volume...
Re: 10-bit
Hi
Presently aim using AD571 ADC.
It have fallowing futures.
Complete A/D Converter with Reference and Clock
Fast Successive Approximation Conversion: 40 ms max
No Missing Codes Over Temperature
08C to +708C: AD571K
–558C to +1258C: AD571S
Digital Multiplexing: Three-State Outputs...
Set point
Hi
Now I want design a variable set point (set point for input voltage) controller.
Can you give information about variable set point controller.
Thank you
Regards
Nari
Hi friends
Here iam displaying the Voltage on 7 segment display
In this program iam facing diaplay probalm
It is flickering and not showing the correct values on the display
Please solve this problam
Regards
naresh
/* Program for display analog voltage On 7 segment display */...
Hi
Iam facing displays flickering problem since last 20 days.
Iam using delay but I am not able to salve it
Here iam using 74LS373(4) latches.
Iam sending the data through PORT 2 and enable the latches using PORT 3
Iam using ADC804+89c51+74LS373(4 numbers) +7 seven segment displays...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.