Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Re: Current filter , Can u help ?
Hi Mr BradtheRad
if this true why the multimeter can read the value without any problem and without delay !!
i don't know what the filter inside looks like !?
thanx
Re: Current filter , Can u help ?
Mr phoenix
the problem is not how to read .
the problem how to filter the crazy oscillations in the signal generated by the current
this is my conditioning circuit in these 2 pictures
i think the idea is to use digital filter ?
or can anyone help...
Current filter , Can u help ?
Hi everyone
I have a problem of current filtering with my controller of brushless dc motor (BLDC).
the problem that the current is PWM and i want to read it and show a fixed value like the multimeter process.
so what's the filter that can be used to prevent...
Hi Mr HTA
Sorry for being late
My goal in my project is to do a gimbal brushless motor 2 axis.
the board used by the engineers contains micro,gyros, accelerometer and (L6234d). this IC is for sensorless brushless motor control .
My question is how they can control this accurate gimbal...
Hello Mr HTA
thanx for you reply.
u said that the control of position will be by an encoder, but the problem is in the sensroless bldc that can't (according to the application notes) be rotates with a speed under 100 RPM = 1.6 RPS !!
so how can i control this bldc with a min speed = 1.6 RPS
so...
Hi Mr FvM
the ring modulator is special for AM modulation, but in this circuit i want to know how a DC signal is converted to AC??
I understood that if it's a positive dc input voltage ==> the ac signal is in phase
and if negative, the ac is out of phase .
but how the output ac signal is...
hi
it's a hard circuit with the explication
i didn't understand it, is it logic !!!!???
Crystal Diode Modulators
The crystal diode modulator (fig. 2-17) consists of a diode bridge and a transformer network. When the ac reference voltage is applied to transformer T1, diodes CR2 and CR3...
hi everyone
I want to do a ciruit that produce a voltage from -70 to +70.
so I decide to use the h bridge with a LC filter.
and this is the general purpose by hip comany:
the values of components is :
* diode mur130
*capacitor 100nF
*resistor Hdel and Ldel = 200K
* mosfet irf520
As you can...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.