Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
once the relay is switched on it wont get turned off. I have measured the voltage on coil in off state and it is somewhere around 8V and dropping to zero i have attached the ckt,
can any one help me out ??
I'm getting the following sms on St-Ericsson modem which is what I'm sending:
And this is what I'm receiving on D-Link/Qualcomm Modem:
Even when I tried sending sms through modem it is giving error on command (at+cmgs). I'm really stuck here and I can not seem to understand what is causing...
I have changed the PDU mode to Text Mode. As I said, ST-ERICSSON is showing the exact sms I'm sending. I have tried using D-LINK modem and still getting the same response as qualcomm one :(
I have two modems (ST-ERICSSON and Qualcomm). I'm testing my modems on hyper terminal to see if it is receiving the right sms or not. ST-Ericsson seems to be working fine but in qualcomm modem I'm receiving garbage data. I have set the baud rate from device settings also using at command but the...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.