Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
:( :( let's c...who has the answer...by the way I got the way to check the configuration bits while simulation...it was just there :)...but still the main problem of table read and write persists...:(
Hi wp100,
thanks for the reply...but I didn't get your above instructions for the solution to my problem. :(
Here I would elaborate a bit more what is the problem, then u might help it accordingly:-
Here is a piece of code I've written in MPLAB X for C18 compiler:-
#include <stdio.h>
#include...
Hi,
I am working on a problem in which I have to set the last three bits(2-0) of the register CONFIG1L (which are PLLDIV2, PLLDIV1 and PLLDIV0) through the code section of my program(e.g. as I access TRIS registers) which is usually accessed and set by "#pragma config PLLDIV"statement.
But...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
