Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Came across these on a website, no answers though..
Guess it would be benificial to everyone if we can answer these!
1. What are the factors you consider for the selection of ADC ?
3. How do you determine the number of bits of ADC is required for you ?
4. Which factor determines the number of...
Hey guys,
So I have an interview coming up with A.M.D. for a "Mixed-Signal Custom Layout" new grad position at A.M.D.... does anyone have experience with this position? What kind of stuff I will need to know for the interview?
Thanks!
No no, not a homework assignment. The topics are too broad to be honest to be covered in a single course.
But this is just to help me revise the basics and have a reference to go to when I need a refresher, should help others too!
Hey guys so Ive been studying upon these topics recently and these are some questions that I was presented with from discussing these topics with other electronic engineers.. any help is appreciated :)
1. How do you lay a PCB board out?
2. Define Gain margin and Phase Margin
3. What is...
Hey,
So what I did was an AC sweep (logarithmic) and I got a gain of about 1.6V. I guess it works, cause if I change my aspect ratios for the transistors, I get an even bigger gain.
So now the question is, how can I optimize this? Should I have a bigger resistance value, or a adjust my W/L to...
Hi, thanks for the reply. I have a few questions:
When you say remove the current mirror, do you mean the current source? Or the transistors we have above the diff pair? Also, what do you mean by sweep our w?
Hey,
So I am given a task to design an amplifier with a current source which I have to design as well (but for now, I just want the amplifier to work, so I have used the default IDEAL CURRENT SOURCE symbol and set a value for it).
Do you guys have any tips? I have posted some pictures below of...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
