Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
HI everyone.
I want to know certificate of GSM/GPRS antenna ( used for modem). I find in some company but they only give CE, FCC part 15, not detailly. I read FCC part 15 but they only have frequency range in small partion of GSM frequency.
I want to know certificate of some factor like...
Hi Everyone. Nice to meet you all
I need transistors for broadband power amplifier. Working frequency is from 6 to 9 GHz. Power out is about higher than 10dbm. Anyone know the kind of transistor please tell me.
THank you for your reading
I need to design an antenna and a rectifier circuit at 27 Mhz in order to measure the strongness or weakness of the 27 Mhz signal by multimeter. please give me instruction for calculation of value of the single diode, rectifier capacitor, resistor
Thank in advance
HI
I am designing remote control for toys. The operation frequency is 27 Mhz. The problem is that the boss want me to identify between each toys. Means that each transmitter working only with one receiver. I think we need a transmitter IC which can encode the signal and receiver IC wich can...
Do you guy have step by step design instruction for ADS or AWR
---------- Post added at 07:59 ---------- Previous post was at 07:13 ----------
In designing this amplifier , did we use S parameter method to design. Or we use what kind of design method
Thank you for the answer.
My question is that how to calculate the amplifier before antenna. I used to design amplifier for 50 ohm impedance matching for the antenna withh 50 ohm input impedance at 11 Ghz. But this kind of low frequency I do know how to calculate it. Do ou have material for...
Does anyone have low power 27MHz amplifier (working below 9V Vdd) ( for transmit signal up to 100m). I found MIC919. IS this okie for this application
THank for reading
Re: Hole in Microstrip
Yes . It is possible. I have already make it but I forgot how to make it. My ads now is not working now so I can not redo it. Sorry
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
