Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
hey friends
I have got and problem with the 4 Mhz oscillator with pic16f877a.I have programmed a code using mplab for sending string to labview and when i check the output value from the PuTTY software I got and output as in picture i attached instead of getting string.But in proteus simulation...
Thanks for the reply . So i need pickit 2 for burning hex file to microcontroller. Can i use the below linked product for this purpose?
Thanks for the reply. Yes it is Icsp . So i need pickit2 to burn hex file to microcontroller then.
Can i use this product for this purpose
**broken link removed**
how to Burn hex file to pic16f877a microcontroller ?
I recently got the mini system pic development board (PIC-DIP40)
But donot know how to burn the microcontroller.so please tell me the process to burn.
Thanks and am i right the pins used for relay driver is RB0,RB1,RB2,RB3...and also tell me that which other pins has been used in this code for this project
can you guys help me which analog pins are used for analog reading for the voltage,current,speed,temperature. and for respective relay driveres
#include<pic.h>
#define ent1 T1CON=T1CON|0b00000111 #define dist1 T1CON=T1CON&0b00000110
#define load RB3 #define motor RB0 #define heater RB2 #define...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
