Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
ftdi sample
Hello
I've asked for samples from cirrus logic two years ago and still nothing since then... :/
Is there someone who managed to get a sample from cirrus here ?
I haven't heard of CAN standard protocols with parallel connections. My guess is that you need to route frames to a working bus by hand.
There are faults detections and tolerance over CAN, but no way to automatically switch from an unworking bus to a working one. You can also send simultaneously...
What do you mean by "reservation of channels" ?
CAN is a message-oriented network, which packets are priority based, I don't how you make a connection between CAN and "channels"
ht1621 sourcecode
Hi,
I don't know what is inside your ht1621_writecmd() function. You know, a HT1621 command is 9 bits long and the ID to send after toggling the _CS signal is 3 bits long.
I wrote an initialisation subroutine in PIC16 assembly. The sequence I used is (by the way, my LCD is a...
PCM2900 Eval board
Schematic is avalaible on TI's site :
see the user's guide of DEM-PCM2900 / 2902
https://focus.ti.com/lit/ug/sleu024/sleu024.pdf
there's also PCB included.
Regards
diy psoc issp programmer
Everything you'll need to design a DIY-programmer is in Cypress Appnote AN2026.
I made one easily using LPT port, with a 74F125, a 74ACT04, a 4-MHz ceramic resonnator and a 7805 regulator (thus no MCU needed ! 8) )
I found that very precise clocking is not necessary...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
