Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
CD,
i build a icd2
.it programs the target pic very well,when i release the reset , taget runs.
but after i using it in debug mode, i connect icd2, it's ok,and i press the menu , debugger->program
the message:
MPLAB ICD 2 Ready
Connecting to MPLAB ICD 2
...Connected
Setting Vdd source to...
atmega fuse bits
hERE IS a Parallel Programmer which using @vrstudio STK500 software, IT is updated now , and firmware will be upload this night of cn, www.zzxp.cn/asnake/down.asp?ID=30
These are three PDF files in the rar file ,an hex firmware in it . Thanx :)
If you want using the button pin...
bl010101.hex disassembled
maybe the target device "debug" fuse be set wrong . Thanks for your sch of using 876a as a icd2. You disassemble icd2 hex file, and reassemble it using 876a?
win8051 simulator
Search sst mainpage, and look for "softice". And it will be a link like this "h**p://www.sst.com/products/software_utils/softice/index.xhtml"
Good luck
pc keyboard with 51 in c
HERE is a keyboard with avr chip
h**p://www.@tmel.com/dyn/products/app_notes.asp?family_id=607
I remember a keyboard with 51 ON this @tmel PAGE , but cann't find now!
Hard disk Over USB
yes,please look here , it's a simple prj get data from IDE .
You can port it to avr chip, or other chip.
h**p://w*w.pjrc.com/tech/8051/ide/
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.