Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi ,
I am trying to find a way to simply extend the input voltage range of a TPS563200 device or alike that will enable input from 4.5V-21V instead of 4.5V-17V ( the original range of the device).
First coms in mind is a FET feeding the VDD of the device by controlling its gate using zener at...
I am trying to divide a 100Mhz input CPLD clk by 4 and take out this 25Mhz to another CPLD pin.
I need the best Jitter from a MACHXO2-256 device.
I am aware of the fact that placing my counter close to the IOs will help and adding FF on the counter's output will also help.
I need a working...
ac to dc without neutral line
Hello ,
I am looking for an inwall battery charger that can work only from the Phase line that is in that wall. There is not netral line there.
this AC/DC should be small and supply about 100mA .
Any ideas ?
Thanks in advance ,
Arik p.
verilog code for pwm
Hi ,
You can use an excel to simulate this. Simply this is doing a modulu of the input data (which is the PWM ratio) on an internal counter. The overflow (over 128) is the value of the PWM.
PWM CNTR INPUT VAL
0 0 70
0 70 70
1 140 70
1 210 70
0 24 70
0 94 70
1 164 70
1...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.