Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
hi,
can any one please tell me how to change the color of shapes.
I'm doing supply planes for the board, and all the supplies are of same color, makes very difficult to figure out which is which.
thanks in advance
thanks kapil,
I've attached a snapshot, i'm unable to get uniform spacing between the rf line & the shield over the route length.
let me knw if u need any other info.
hi,
I have a RF line of 15mil width, i need to shield this line with a ground line and the spacing between the two should be 45mil.
how to do this in orcad?
your layout cell name should be less than 32 characters. If the name has more than 32 char, calibre takes only the first 32 char and the cell name u specify will be different than the name in gds, hence the error...
hi,
I'm doing layout of a filter on diff paths..
so the components (R, C & L) must be placed symmetrically.
I've done placement on one path and (for symmetry) copied the components & placed them on the other path.
but the problem is i'm not able to map the copied components (symbols) to the...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
