Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Dear friends,
This Group is dedicated to solve ADS, EMPRO, Genesys and other Agilent EEsof product related queries. You can find study material, tutorial, links, design help here in this forum. Please do ask questions and provide solutions. ... :)
Thanks
Amit
drkirkby,
You are right ADS is not very help full in PCB drawing right from scratch, but it is capable enough to modify previously created PCB from other PCB designing tools(like Allegro, Mentor Expedition). ADS has various links to bring their layouts to ADS.
You can ask her to Create a...
Sika,
Multi resonance is not a issue. One thing I would like to know is what application are you targeting with this antenna, is it ISM band for Mobile Communication ?(as I can see a resonance at ~2.4 GHz). There are various factors you need to see before designing an antenna.
1) What is the...
you can refer to various CPW FED UWB Antennas. there are many research papers for that, here are some of the research papers you can look into
1) A COMPACT CPW-FED UWB SLOT ANTENNA WITH CROSS TUNING STUB from J. William and R. Nakkeeran.
2) A Compact Slot UWB Antenna with CPW-fed from I-Tseng...
Slot line are created using slot definition to the layer mapping in substrate editor. Its a negative artwork. your can follow following steps to create your design
1) Create a design negative to your desired design(remember you need to create design of the vacant slots in layout using draw...
You can use ADS design guide for beginners help, it creates the topology for the beginners and then you can specify the frequency limit you want for your LPF.
------
Amit
ADVERTISING LINK REMOVED
Follow below mentioned steps to design a Microstrip Patch Antenna
1) You need to create a rectangle in Layout with width =2.3 and Length = 3.6,
2) Now create a substrate according to your Antenna design.
3) Now design a feed line with 50 ohm impedance(use line calc to calculate the width of...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.