Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I'm Using "RS232- 1200 8-bit no-parity inverted", i had test even parity bu didn't works.
Receiver Module Datasheet:
http://roboeq.com/PDF/0501017.pdf
Transmitter Module Datasheet:
http://roboeq.com/PDF/0501016.pdf
Please help i want know the frequency mix in space ?
My collage master said...
18F4523 Have internal EEPROM don't need to external EEPROM
See Mikroe EEPROM Library help it's easy to use.
"
program Eeprom
dim counter as byte ' loop variable
main:
ANSEL = 0 ' Configure AN pins as digital I/O
ANSELH = 0
C1ON_bit = 0...
Using two or more FSK module in a one place is it possible ?
Hi Guys,
I have FSK 915Mhz Transmitter and Receiver module i wrote simple program with StartID and StopID for increase accuracy everything is good no problem at all.
now if i buy three Transmitter and Receiver at same frequency...
Thanks, i used it before by getting A/D value and seek for maximum value by compare from last A/D value after that i divide this value by 1.4142 to get Effective current .
^^^^^^^^^^^^^^^^
T1 = ADIN 0
IF T1 < 512 THEN EXIT
IF T1 > T2 THEN 'the sinus wave is increasing
T2 = T1...
Hi,
I use ACS 756 (Allegro Current Sensor) it's hall effect sensor with just have 5-pins VCC, GND, Output, IP+ and IP- the output have scale of actual current from primary conductor to calculate current (Nominally 66mv per Amp) when the primary conductor current is zero the output voltage is 2.5...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
