Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
The scheme is provided in the message. The source of an alternating voltage is entered for noise creation. Thus start of modeling shows voltage a straight line (I start dc sweep with voltage step). How it is correct to simulate noise to see it on graphics? Prompt what to press in PSpice.
How to define time of charging of input capacity of ADC (it is designated as C4 on the diagram of connection of a thermal sensor to the microcontroller) ? I attach the general diagram and the equivalent circuit which I simulate.
I am limited in connection by RF1 and RF2 connectors of the experimental board. It isn't possible to find their characteristic to select to itself the necessary 2 outputs for my sensor (ground and power). Can you help me ? I looked for information in board and microcontroller documentation. I...
Where I can get the diagram of connection of a thermal sensor TC1047AVNBTR to the ADC of microcontroller MSP430F4618 ? Also interestingly, on what formulas it calculate ? Thank you.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
