Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hello,
I am starting to use WCH microcontroller using MounRiver IDE, in particular the CH32V003F4U6, this uC has 16K flash and SRAM 2K,
I use this a simple code:
#include "debug.h"
/* Global define */
_Bool Sx_Op_Flag = 0;
float Temperature = 0.0;
uint16_t iData_SPI=0;
/* Global Variable...
Hello,
I have a motor with the next specs:
Vin : 21V-30V
Inom : 2.7A (Vin=24V)
I_start : 18A
RPM : 3300
Reductor :
Gear ratio : 512:1
The moment on the shaft : 2400 Ncm
Axial_load : 500N
Radial_load : 350N
Electromagnetic brake
Vin : 21V-30V
I nom : 400mA (Vin 24V)
response time : 30ms
stop...
Hello,
I have a converter board DVI to RGB, I conected this board to a TFT LCD MODULE using several cables, i didnt paid much attention to the signal length, and it works perfectly.
I've got another TFT LCD (different company) and i've decided to do a simple PCB board, but it doesn't work...
Hello,
I want to implement a controller for touch screen panel that has 24 sensing channels RX , and 25 driving channels TX.
Reading this document (https://www.researchgate.net/publication/279915514_Concurrent_Driving_Method_with_Fast_Scan_Rate_for_Large_Mutual_Capacitance_Touch_Screens)...
Hello,
I need to get 1V from 5V, it is for an FPGA, Could someone recomend a circuit or IC?.
Most of the DC DC converters that i found work from 1.5V and so on. I found this DC-DC_Step_UP-Down_ZK-SJVA-4X module , which can give from 0.5V output, but i could find the schematic.
I hope can...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
