Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi everyone!
I'm trying to design a tapered microstrip to parallel stripline balun in ADS. I have imported the layout in .dxf with three different layers (upper conductor, dielectric and bottom conductor/ground).
My question is about how to match each substrate layer with its corresponding...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.