Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi,
I have completed my layout design in orcad layout, but facing one problem. The statistics shows that the board is not 100% routed, but I am unable to find any unrouted nets on the board. I have checked the board many times. On generating an unrouted connections report using auto-> generate...
I have found a way, Please suggest whether this is correct or not. First I will save the .max file, .mnl file and the capture design file in different new folder. The previous file will remain saved in the previous folder. Now I will make the required changes in the schematic file stored in new...
Hi,
I have designed an orcad layout file. Now I want to design a new pcb design which is 95% similar to the previously designed file with a slight difference of one or two components.
Is there any method of designing the new file using the previously designed file or do I have to go about...
Hi,
I want to design footprint for QFN48 and QFN16 package.
Please suggest some pdfs or tutorials that I should study to design these footprints in orcad.
Best Regards,
Abhishek Grover.
Hi,
I am using orcad to design pcb layouts.
When I open the capture or layout then I am able to view the schematic or layout files in the design window ,when selecting to save file or when browsing from capture or layout to load a particular file but I am unable to find the schematic and layout...
I will be giving power to my board using a 3V coin cell battery. Therefore I am looking for a low power solution. Tilt detection and motion detection are more important. its ok if tap detection cannot be done. Please suggest one of the ICs I had mentioned or any other alternative for my application.
Physical mechanism that makes opamp input track each other:
Opamp inputs track each other only in the case of negative feedback. In the other two configurations, positive feedback and open loop ,there is no virtual short between the two inputs of opamp. So one should first make this clear that...
I need help in selecting the right accelerometer for my project.
I will be using the accelerometer for tilt sensing, motion detection and tap sensing. I have found three accelerometers which can be used.
1)freescale:MMA8453
2)Analog Devices:ADXL344
3)ST microelectronics:LISDH12
I want to know...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.