Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
If used in CRT monitor , the current load is just a 50 ohm resistor, it's the standerd.
v=Idac*R, and for fully differential, we have two resistors loading on the board.
single ended structure will be enough. I have designed one.
if use single to differetial converter, you can set the gain low than 1 to release the output swing of it.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.