Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
panaterm
Anyone experience with Panasonic motor driver that use PANATERM software link with PC? I am new to this and look for a circuit diagram for the comm cable to use with the PANATERM software. If any one of GURU's in this field could share, much much appreciated. Thanks. :roll:
solder bga?
I think you need to look for metal mask stencil maker.
Or some one that can cut by laser those opening on a
0.15mm stainless steel metal plate. Once you have this
you need to buy a solder paste and appy this on the opening
by using metal squeege.
This process normally is use in SMT...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
