Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Xpedition xDM Library tools error when creating new part

Status
Not open for further replies.

vnenthusiast

Newbie level 4
Joined
Dec 7, 2020
Messages
6
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
43
So I was creating this new part after making the Cell and Symbols for it. I have allocated all the pins as you can see here in the attached image. But when I try to save the part, I still get the error message telling me that there are pins that arent mapped. But all of them are mapped, so I'm not sure which pins the software is talking about. Any ideas?
 

Attachments

  • Capture_1.JPG
    Capture_1.JPG
    70.4 KB · Views: 109
  • Capture_2.JPG
    Capture_2.JPG
    25.6 KB · Views: 115

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top