sujithchakra
Junior Member level 1
xilinx unisim
Hi,
I am trying to do post-translate simulation on Xilinx ISE 10.1 on a PC(Win XP). When I try to compile the UNISIM/SIMPRIM libraries, the system asks for 3rd party simulators. So I installed Model Sim PE student edition. I am again stuck because my design is bigger than ModelSim Student Edition would handle.
My school has NC-Verilog on UNIX machines. Is there any way that I can compile, UNISIM/SIMPRIM libraries on PC for NC-Verilog simulator(NC-Verilog is on UNIX). When I try to compile, I get a message ncsim executable is not found because there is no NC-Verilog installed on PC.
Can any one please suggest how can I get through this phase?
Thanks,
Sujith Chakra
Hi,
I am trying to do post-translate simulation on Xilinx ISE 10.1 on a PC(Win XP). When I try to compile the UNISIM/SIMPRIM libraries, the system asks for 3rd party simulators. So I installed Model Sim PE student edition. I am again stuck because my design is bigger than ModelSim Student Edition would handle.
My school has NC-Verilog on UNIX machines. Is there any way that I can compile, UNISIM/SIMPRIM libraries on PC for NC-Verilog simulator(NC-Verilog is on UNIX). When I try to compile, I get a message ncsim executable is not found because there is no NC-Verilog installed on PC.
Can any one please suggest how can I get through this phase?
Thanks,
Sujith Chakra