Xilinx SoC Zynq 7020 + Flash problema

Thread starter flote21
Start date Jul 10, 2018

Status: Not open for further replies.

Jul 10, 2018

flote21

Advanced Member level 1

Hello folks,

I have designed a customized PCB board based on the evaluation kit ZC7020 of Xilinx. And I am having issued to run the Flash with the preescaler x2 (maximum speed) in my customized board. The same flash chip and same configuration works perfect in the ZC7020. my customized board only achieves x8 o bigger preescaler configurations. I have already checked signal integrity and it is fine to that speed. I am always read 0x0000.
Anyone knows anything about this?

Status: Not open for further replies.

Similar threads

Z
[SOLVED] What command can save out existing flash and then save it back on Xilinx Alveo U280
- Started by zzzhhh
- Jun 12, 2023
- Replies: 0
PLD, SPLD, GAL, CPLD, FPGA Design
Z
I need some cheap Zynq FPGA Board.
- Started by Zerox100
- Feb 5, 2024
- Replies: 2
PLD, SPLD, GAL, CPLD, FPGA Design
K
What's the difference between RAM and ROM with a coe files in Xilinx FPGA?
- Started by kevinwang65
- Mar 11, 2024
- Replies: 13
PLD, SPLD, GAL, CPLD, FPGA Design
[SOLVED] NOR flash read/write for SPI signal integrity mesurements
- Started by dpaul
- May 31, 2023
- Replies: 6
PLD, SPLD, GAL, CPLD, FPGA Design
Z
Xilinx Foundation 1.3 (old) software - student edition anyone?
- Started by Zag4cpld
- Jun 5, 2023
- Replies: 0
PLD, SPLD, GAL, CPLD, FPGA Design

Xilinx SoC Zynq 7020 + Flash problema

flote21

Advanced Member level 1

Similar threads

Privacy & Transparency

Privacy & Transparency