Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronic Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Xilinx post-routing signal names

Status
Not open for further replies.

George_P

Member level 2
Joined
May 26, 2007
Messages
47
Helped
3
Reputation
6
Reaction score
3
Trophy points
1,288
Activity points
1,610
Hello,

I'm simulating a VHDL design after synthesis,placement & routing with the back-annotated model that ISE gives me.

In order to debug it, I would like to find some internal signals. However all internal signal names have new names (different than the ones in the initial VHDL code). These new names probably have to do with the xilinx-cells to which the signals were maped.

Does anyone know how I can search for the new name (post-placement name) of a signal from my initial design VHDL code?
Does ISE provide a way to find this correspondence?
If not how do people proceed to the debugging without access to internal signals?

Thank you in advance,
George
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Top