pic rs232
I am trying to set up a pic16f877 to send and receive commands using the Xbee RF transceiver,i used xbee series 2,at first i sent (atnd,atdb)from pic16f877 attached with coordenator to 3 end devic,
my application requierd to send these information to another local area network(xbee 2 also),if i use the same pic to send to the new area,the problem that this pic16f877 has only one UART(pin 25,26),if anyone can help me pliz or has any other sugestion to communicat between 2 local area network
Added after 15 minutes:
I am trying to set up a pic16f877 to send and receive commands using the Xbee RF transceiver,i used xbee series 2,at first i sent (atnd,atdb)from pic16f877 attached with coordenator to 3 end devic,
my application requierd to send these information to another local area network(xbee 2 also),if i use the same pic to send to the new area,the problem that this pic16f877 has only one UART(pin 25,26),if anyone can help me pliz or has any other sugestion to communicat between 2 local area network