Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Xbee addressing nodes in network

Status
Not open for further replies.
binojkumar

binojkumar

Full Member level 3
Joined
Jul 19, 2004
Messages
151
Helped
2
Reputation
4
Reaction score
1
Trophy points
1,298
Location
Bangalore
Activity points
983
Xbee

Hi I want to make a sensor network which having 4 nodes, one Coordinator and 3 end devices with ADC enabled in D0.(Pin 20).
When ever I send a remote request from the coordinator to the particular node ,it has to respond to the coordinator with the ADC out put. How it can be configured? What will be the destination address the coordinator has to send?
Now I have configured
PANID 3332 for all nodes.
In coordinator , Coordinator enabled 1
End device , Coordinator enabled 0
..etc

my doubt is how we can configure particular node address?
And how we can send a remote request to get ADC out put?
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top