Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

X-i-l-i-n-x CPLD programming cable - Tested

Status
Not open for further replies.

Bus Master

Full Member level 3
Joined
Dec 9, 2001
Messages
186
Helped
9
Reputation
18
Reaction score
3
Trophy points
1,298
Location
Just behind You ;-)
Activity points
1,455
cpld programming cable

Hi all,

Here i upload my implemented version of X-i-l-i-n-x parallel cable for CPLDs, PLCC 44 & 84 pins.

I use it woth I-S-E 5.1i, working great.

N.B. file is in P-r-o-t-e-l-9-9-S-E format.

Enjoy :wink: .

Yours,
Bus Master
 

xilinx cpld programmer

What cable is it? If this is parallel cable IV, please send this schematic in gif or pdf format. (Or protel 3.0.....).
Thanks in advance.
 

reprogramming the xilinx cpld chip

Hi there,

This is the Parallel cable. I'll upload schematic ASAP.

Thanks.
 

xilinx cpld programming

Parallel cable III schematic freely availabe on xilinx web site.
If it is parallel cable IV, I am interested.
 

xilinx cpld parallel cable iii

I need the schematic for Parellel Cable IV too.
 

xilinx cpld programming cable

ramesh said:
Parallel cable III schematic freely availabe on xilinx web site.
If it is parallel cable IV, I am interested.

But the parallel cable IV contains a FPGA and therefore is a little bit more complex. So you also need the program for that Xilinx chip ...


Mik
 

cpld cable iv

what differnce
 

it is good thing.THX! :)
but where are you put it to? i saw nothing here. :?
oo it is ok ,i see the file. :D thx
 

parallal cable 4 design please.
dose some one has one foe altera?
hock
 

Please upload Sch. Thanks a lot
 

I was told by Xilinx FAE that Parallel IV has a custom designed chip (pld). You are not able to duplicate it even if you have the schematic draw. You have to have the custom designed chip as well.
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top