Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Wireless doorbell - helpwtih design needed

Status
Not open for further replies.

ekhorasan

Newbie level 4
Joined
Jul 12, 2009
Messages
7
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Location
Iran
Activity points
1,314
module tlp433

.I have a project like that you had.
I should design a wireless doorbell.Can you help me?
my email address is Delphiir[At]Gmail[Dot]Com

with best regards
M.S
 

wireless doorbell

You can use RF IC pair.
IF not....you have to use a modulation techniques
 

rf doorbell hobby

You may use HT12 pair to make a remote bell. Refer the schematics attached. R1 in TX may be 1M and R3 in RX amy be 47K. Transmitter and receiver modules may be TLP433 which are easily available. Good luck
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top