Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Will a CMOS inverter work as an Amplifier?

Status
Not open for further replies.

vlsi_whiz

Full Member level 4
Full Member level 4
Joined
Nov 12, 2005
Messages
216
Helped
49
Reputation
98
Reaction score
24
Trophy points
1,298
Location
Penang
Activity points
3,139
unbuffered inverter linear

Can anyone provide me some insights on this topic?

Will a CMOS inverter act as an amplifier under normal bias conditions? Will it amplify signals if it is biased at Vdd/2? If so, can any one give me a small explanation?

Thx
 

Davood Amerion

Advanced Member level 2
Advanced Member level 2
Joined
Mar 1, 2005
Messages
579
Helped
116
Reputation
232
Reaction score
24
Trophy points
1,298
Location
Persia
Activity points
6,345
cmos gmcell

I think it is possible, because input impedance is very high and it has voltage gain.
but it is unusual and will draw more current from VDD.
It is better to use another IC for this purpose!!!!

regards
Davood Amerion
 

sunking

Advanced Member level 3
Advanced Member level 3
Joined
May 25, 2004
Messages
873
Helped
70
Reputation
140
Reaction score
23
Trophy points
1,298
Activity points
6,283
of course you can.
1. such as two stage opa, the last stage can be an inveter
2. use self-biased, you can use the inverter as an opa
 

cherrytart

Advanced Member level 4
Full Member level 1
Joined
Feb 26, 2002
Messages
117
Helped
5
Reputation
10
Reaction score
1
Trophy points
1,298
Location
oklahoma
Activity points
1,037
the older simpler stuff for sure, like an unbuffered inverter from the old 4000 series. other than input protection, one of these inverters is just 2 totempole transistors.
 

Fom

Advanced Member level 2
Advanced Member level 2
Joined
Mar 10, 2004
Messages
630
Helped
84
Reputation
168
Reaction score
32
Trophy points
1,308
Location
Taiwan
Activity points
4,463
Connect input to output through 1M resistor and you will get amplifier. This amplifier is often used in quartz oscillator circuit.
 

suria3

Full Member level 5
Full Member level 5
Joined
Mar 5, 2004
Messages
300
Helped
17
Reputation
34
Reaction score
5
Trophy points
1,298
Activity points
3,027
I agree with Davood, it is possible to use it as an amplifier with the gain,
A=Vout/Vin= 2*(gm1||gm2)*(ro1||ro2) but at the tradeoff with current from VDD.

For better amplification, u can use common source amplifer which will give you high gain with lesser current and more realistic.
 

skal81

Full Member level 2
Full Member level 2
Joined
Jan 19, 2005
Messages
121
Helped
38
Reputation
76
Reaction score
18
Trophy points
1,298
Activity points
1,478
Yes it is possible and called a Nauta's gmCell.
You can refer to "A CMOS Transconductance-C Filter Technique for Very High Frequencies" published in IEEE Journal of Solid-State Circuits, vol. 27, no.2 February 1992, pp 142-153. (sorry I don't have the PDF of the file)

It describe a transconductor (base for an amp) using an inverter. Actually 2 because it's a fully differential structure. The CMFB is also realized with inverters.
 

mady79

Member level 5
Member level 5
Joined
Mar 30, 2004
Messages
91
Helped
7
Reputation
14
Reaction score
1
Trophy points
1,288
Activity points
922
Inverter behaves as an amplifer if input signal does not saturate any of the
p/nmos transistors .pmos amplifies lower half of the input signal and nmos amplifies higher half of input small signal .singal swing has to be around the trip point of the inverter for good gains and make sure input swing does not saturate to rails .

It has the same problem as any other single ended designs ,trip point variations
due to supply ,one can notice this having more gain for positive cycle and less gain for negative cycle .
 

zorro

Advanced Member level 4
Advanced Member level 4
Joined
Sep 6, 2001
Messages
1,130
Helped
357
Reputation
712
Reaction score
298
Trophy points
1,363
Location
Argentina
Activity points
8,909
cherrytart said:
the older simpler stuff for sure, like an unbuffered inverter from the old 4000 series. other than input protection, one of these inverters is just 2 totempole transistors.
Exact. Use UB (unbuffered) series instead of B (buffered) series, inthe way Fom described. With buffered devices, the several (odd number of) inverter stages can be working in bad operating points.
There is an Application Note (I guess that fron National) on linear application with CMOS logical gates.
Attention: the static current can be excessive in some devices when polarized in this way.
Regards

Z
 

muralikrishnap

Newbie level 5
Newbie level 5
Joined
Jul 13, 2005
Messages
8
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,340
yes

when used in satyuraton region of opearetion

Added after 1 minutes:

yes
 

tandr

Member level 2
Member level 2
Joined
Jun 21, 2006
Messages
43
Helped
1
Reputation
2
Reaction score
1
Trophy points
1,288
Activity points
1,539
Yes , and just think about the transfer curve,
you will find the gain is high
 

shaikhsarfraz

Full Member level 5
Full Member level 5
Joined
Aug 8, 2006
Messages
285
Helped
25
Reputation
50
Reaction score
6
Trophy points
1,298
Activity points
2,961
Hi,
In saturation region invertor works as Amplifier with the gain given as
Gain = -gm*Rds.

In saturation region the gain is also given as
(Vout/Vin) = (Vdd + Vtn + Vtp√(Bn/Bp))/(1+√(Bn/Bp)).

thanks
sarfraz
 

tandr

Member level 2
Member level 2
Joined
Jun 21, 2006
Messages
43
Helped
1
Reputation
2
Reaction score
1
Trophy points
1,288
Activity points
1,539
Yes , in fact I just design a circuit use inverter
amp as the amplifier unit
 

rajkumaru

Member level 5
Member level 5
Joined
Jul 11, 2006
Messages
83
Helped
7
Reputation
14
Reaction score
2
Trophy points
1,288
Location
Bangalore(INDIA)
Activity points
1,692
When trx work in linear region then it is inverter and when trx of inverter work in saturation region then it work as amplifier
 

shaikhsarfraz

Full Member level 5
Full Member level 5
Joined
Aug 8, 2006
Messages
285
Helped
25
Reputation
50
Reaction score
6
Trophy points
1,298
Activity points
2,961
Hi,
I have a doubt regarding this statement.

rajkumaru said:
When trx work in linear region then it is inverter and when trx of inverter work in saturation region then it work as amplifier

The inverter operation of the transistor is digital operation, which is because of the switching operation of transistor. For switching the transistor switches between linear/saturation and Cutoff region. So for inverter operation it is not required that the transistor should only be in linear.

For using it as an amplifier we use it in saturation region because the gain of the transistor is highest at that point.

thanks
sarfraz
 

roykyn

Full Member level 5
Full Member level 5
Joined
Sep 15, 2006
Messages
253
Helped
12
Reputation
24
Reaction score
5
Trophy points
1,298
Activity points
2,704
see 74hct14 datasheet........
 

Humungus

Full Member level 6
Full Member level 6
Joined
Jul 10, 2001
Messages
383
Helped
41
Reputation
82
Reaction score
15
Trophy points
1,298
Activity points
3,985
Of course it can. Actually most crystals oscillators in micro controllers use an single inverter as crystal driver. The gain is roughly linearized by a feedback resistor.

Actually the inverter is a no very good amplifier in the sense of its analog characteristics: offset, linearity, rejection, etc.

But, anyway it is an inverting amplifier
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Top