Why use 0 Ohm Resistor

Status
Not open for further replies.
Most of then are for EMI, impedance matching and function debug!
 

hi all;

0 ohm resistors is also sometimes used as fuse , it depends on size of the resistor :1/8 W , 1/4W or ...

but ususally it is used where the fuse shouldn't burn easially
[/img]
 

On the old 8700 Motorola mobile phone there are two resistors on a ground plane, see picture; probably used during layout to connect different grounds on the schematic diagram.

Mandi
 

cube007 said:
Hello,

If you have a system with analogue and digital GND which have different names (AGND/DGND) in the schematic you can use 0 ohm resistors for connection analogue and digital GND.


Bye,
cube007
Click to expand...

i think a better way in such cirsustance is to use a inductor rather than a 0 resistor.

In fact, 0 resistor is used as a jumper in most designs.
 

hi :
In high speed design, o resistor can minish 'stub' effect when it beening used as a switch.
 

Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…