Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

[SOLVED] Why separate "Vs" and "Vss" at pin no. 8 and 16 respectively are used in L293D?

Status
Not open for further replies.
S

shantilal.s50

Junior Member level 1
Junior Member level 1
Joined
Jun 8, 2013
Messages
15
Helped
1
Reputation
2
Reaction score
1
Trophy points
3
Location
Jaipur
Visit site
Activity points
110
Why separate "Vs" and "Vss" at pin no. 8 and 16 respectively are used in L293D?

I refers to the datasheet of L293D (STMicroelectronics) and it was found that separate "Vs" and "Vss" at pin no. 8 and 16 respectively are used but it was not mentioned that why we are doing so?
 

Re: Why separate "Vs" and "Vss" at pin no. 8 and 16 respectively are used in L293D?

Have a look at the TI data sheet www.ti.com/lit/ds/symlink/l293d.pdf

The SGS terminology is bad as Vss normally means 0V or GND!

Pin 16 is the logic supply, 5V for example. Pin 8 is the motor supply - see figure 3 of the TI data sheet.

Keith
 

Re: Why separate "Vs" and "Vss" at pin no. 8 and 16 respectively are used in L293D?

Thanks Keith.
I got it.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top