Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

why is there not "command" in propertie when i imp

Status
Not open for further replies.
L

legyptien

Junior Member level 1
Joined
Nov 14, 2009
Messages
16
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Location
montréal
Activity points
1,412
hello,

I m using HFSS 12. When i creat a new project and i do a simple cylinder. if i click on it and i do "edit", and then "properties". it shows me "command" and "attribut".

But when i do a project more complex and i click on something, i do "edit", and then "properties", it doesn't show me "command".

Did anyone get this problem before ?

Thanks :)

EDIT: ok i know the reason, it is because the big project, i have imported it from CST to HFSS. is there a way to see "command" in properties even if the project has been imported ?

thanks
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top