Re: why FDG901D (p mosfet driver) can not drive FDN360P mos
Hi, for the FDG901D the max supply voltage is only 10V. In your schematic you are using 12V. Perhaps this is a mistake in your drawing or the chip is allready gone. Is there some reason why you are not using an ordinary transistor and some resistors? If it's a matter of space you might have a look at the resistor equiped transistors like the PDTC115ET. Also, for the FET, if you want to use an other type, be carefull. Some recent Fairch. FET's have a max. GS voltage of 7V. Exceeding this voltage can distroy your FET.
Regards