[SOLVED] why code works well in keil but not working on real hardware

[ALMIGHTY TECH]

my .c code works well in keil .( i am using 89s52).
but its not working in hardware..
i have changed all the component and power supply as well..
and also try it on new development board..
i also try with new micro controller ...
please give any suggestion..

why it works well in keil ....... but not in hardware..

 

[wp100]

Hi,

Its quiet common for programs to run fine in simulations but fail on the hardware.

A common mistake is on the hardware and software for the oscillator.

Do not know the 89s system, but you need to post your code and circuit diagrams for anyone to be able to help you.

Also say what is not working, all of the program or just a part of it ?

 

[nandhu015]

First try simple blinking led program with your hardware, if it works fine most probably there must be some logic error in your code.

Be elaborate in your posts.

 

[ALMIGHTY TECH]

when i face error,, i tried with simple blink program.... but its not working... and also i test my hardware... there is not problem with my hardware... i try with replacing new microcontroller .. but it also not working.. i cant find the problem... i am uc unipro111 programmer..

 

[ALMIGHTY TECH]

unipro111 shows program ok... , but is there any chance of fault in programmer or in keil ...?????
kindly reply genius people....;

 

[ALMIGHTY TECH]

i install keil in new fresh pc... and make blink program.. but it also not work..
problem was in secure bit..
problem solved by secure bit..
just enable secure bit and everythings works fine...

can anyone tell me that.. why secure bit is needed....???

 

[ALMIGHTY TECH]

problem was the secure bit.. make sure all the security lock bit are enable..