Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Which software can i use to program a cypress uC

Status
Not open for further replies.

The Cat

Newbie level 3
Joined
Oct 4, 2004
Messages
4
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
33
i can but a PSoC controller board with a CY8C26643 on it

Which software can i use to program this uc?
 

Hi,
Check out:
http://www.cypressmicro.com/
You can find all the information you need about those u-controllers.

On the right side of the page, you have links to "3rd Party Tools" and "$398 Basic Development Kit" (does not have your device listed) and the "Device Programmers".

So, I think that is a good start to look for informaiton,

Best regards,
/Farhad
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top