where am i doing wrong? (CST antenna model)

Status
Not open for further replies.
A

asondas

Junior Member level 2
Joined
Jul 4, 2007
Messages
23
Helped
1
Reputation
2
Reaction score
0
Trophy points
1,281
Activity points
1,411
hi;
im going to remodel the referance antenna in the paper named "Printed Double-T Monopole Antenna for 2.4/5.2 GHz Dual-Band WLAN Operations" (IEEE TRANSACTIONS ON ANTENNAS AND PROPAGATION, VOL. 51, NO. 9, SEPTEMBER 2003).
the antenna has only one resonant frequency between 2130-2535MHz, but in my CST simulation it has 4 resonant points. and also i remodelled it by using HFSS. it has one resonant but it has a frequency shift.

im uploading the paper and my simulation files.

please could you look at it?
where am i doing wrong.

thanks for your helps.
 

hi!

you have wrong waveport definition both in CST and HFSS. I used a lumped port in CST (Take a look at the attachment).

Please try to find documents how to define waveports (seach in edaboard, there are a lot).
 
Reactions: salma

    S

    salma

    Points: 2
    Helpful Answer Positive Rating
thanks for your help
 

hi shameemkabir;
how can i know, which port must i use?
when i looked the antenna design example in cst, waveport is used in it.
 

asondas said:
hi shameemkabir;
how can i know, which port must i use?
when i looked the antenna design example in cst, waveport is used in it.
Click to expand...

You can use both ports in this case. As a first simulation you try with lumped port (if you want only one mode). If the result is satisfactory, you draw the waveguide port. However, it is always better to use waveguide port, since it also shows you the field at the port. You should get very close results for both.
 
Reactions: salma

    S

    salma

    Points: 2
    Helpful Answer Positive Rating
Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…